Motobatt Fat Boy 9 Step Battery Charger 12 Volt 2 Amp

Features:

• 12 volt 2A Intelligent 9 stage Battery Charging system
• Compatable with batteries of 10Ah to 80Ah
• Automaticly turns on and off as required to maintain the battery at full charge
• Ideal for charge and maintenance of all types of battery such as Sealed, Maintenance free,GEL & AGM batteries without overcharging.
• Ideal for charging Motorcycle, ATV, Snowmobiles, Jetski, Boat & Lawnmower batteries.
• Charger lead length is 240mm Long Plus the connector lead (140mm Long)
• Each charger is supplied with a set of interchangeable crocodile leads (140mm L) and weatherptoof permanent terminal leads (140mm L)

9 Staging Charging and Maintanence Process

1. Qualification Phase:

Initially ensures that the battery is in good condition prior to launching charge processing. As a safety measure charge process will

not begin if the battery is below 2.0V.

2. Battery Rescue Phase:

MOTOBATT Battery Rescue starts it the battery voltage has risen unusually high in the early portion or the re-charge cycle.

This is usually caused by plate sulfation. Once the battery rescue phase has succeeded in getting the battery to accept power,

normal battery charging will begin.

3. Soft Start Phase:

Soft Start is used when the charger has detected a battery at a very low initial state of charge. Voltage and current are delivered

at specified rate to help the battery to recover prior to entering Pulse charge mode.

4. Pulse Mode Phase:

MOTTOBATT Pulse mode provides a high frequency pulse charge to help the newly recovered battery to continue to accept

charge as it enters the reconditioning phase.

5. Recondition Phase:

The MOTOBATT reconditioning phase continues to work the battery at a slightly higher voltage and amperage to

"re-activate" the battery plates for improved depth of charge and charge acceptance.

6. Bulk Charge Phase:

With the battery now through Pulse and reconditioning phases and well on its way to full recovery the MOTOBATT bulk charge phase gives the battery

constant current taking the battery up to 80% of its capacity.

7. Absorption Phase:

In the MOTOBATT absorption phase the battery is given constant voltage while the current is reduced based on action taken from monitoring the

batteries current state until the battery is 100% charged.

8. Check Phase:

Battery is now checked to be sure that is holding a charge properly and a charger will make determination and classify the battery for use.

9. Maintenance Phase:

Battery can be left safely on the charger indefinitely. The unit wills monitor the battery and "turn-on" again as needed to maintain the battery

at a full state of readiness.